Surface rotation

Moderator: GiD Team

Posts: 9
Joined: Mon Feb 06, 2017 3:55 pm

Surface rotation

Postby marcosasilva » Thu Nov 14, 2019 9:13 pm


I'm modeling a prismatic volume where the bottom surface is supported by a surface spring.
Additionally, the rotation of this bottom surface needs to be restrained (i.e, all the surface nodes have equal vertical displacement)

There is a way to avoid the surface rotation without using surface constraints?

GiD v10.0.9
User avatar
Posts: 1649
Joined: Thu Sep 18, 2014 3:31 pm

Re: Surface rotation

Postby escolano » Mon Nov 18, 2019 3:49 pm

These characteristics depend on the type of problem used for the simulation, not GiD
The boundary conditions and its meaning is defined by the problemtype, and from GiD you assign them to the model.

Probably you are using some structural code with 'solid elements', and the 3 degrees of freedom are the displacements of the nodes,
then you must simply set that the displacement in x and y is zero for the surface nodes (assuming z vertical)

Return to “Geometry”

Who is online

Users browsing this forum: No registered users and 1 guest