http://www.gidhome.com/forum/viewtopic.php?f=9&t=3715
Using the recommendations from the thread in this url:
http://www.gidhome.com/forum/viewtopic. ... 6&start=10
I have also modified the configuration to "Debug" in the scripts\ConfigureProgram.tcl file as explained by the pdf in this url:
ftp://www.gidhome.com/pub/GiD_Conventio ... 20code.pdf
In other words, I am now able to launch and debug procedures in RamDebugger using these two commands:
Code: Select all
-np- my_test
-np- source {your_full_path_to_your_file.tcl}
In GiD 12.0.9 (trial version) this works fine. In GiD 13 this freezes the entire program after the blue bar at the bottom of the RamDebugger session appears:
I would like to fix this or find an alternate way of ending the debug session before the entire tcl procedure I have called through the GiD command -np- test executes. Some of my procedures are very long and it is unnecessary to step through the entire procedure to debug the line I want.
Thanks