[GiDlist] Problem Safir -GiD interface
Posted: Thu Feb 23, 2012 6:06 pm
Hi all;
I am trying to run a model for Safir. I disconnected some beam 3D elements degrees of freedom at some nodes to simulate pinned connections (elements do not transfer bending moments in some axes).
When the run is launched; an error message pops up in the screen.
I opened the txt file (in and OUT files are not created) and an error message says the model exceeds the maximum number of beams that can be associated to "Disconnect_Id" (100)
I found that error in the past and tried to overwhelm it generating several Id with the same disconnected degree of freedom so that the number of beams per Id were fewer than 100.
I did not succeed. Does anyone know how to overwhelm this limitation? Otherwise the capacity to disconnect degrees of freedom in Safir - Gid is quite limited.
Thank you in advance !
Javier Unanua
Senior Engineer | Fire Engineering
Arup
C/ Alcalá 54 E28014 Madrid Spain
t +34 91 523 92 76
f +34 91 521 85 75 m +34 696 23 35 31
www.arup.comhttp://www.arup.com/
____________________________________________________________
Electronic mail messages entering and leaving Arup business
systems are scanned for acceptability of content and viruses
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://listas.cimne.upc.edu/pipermail/gidlist/attachments/20120223/5abb8506/attachment.htm
I am trying to run a model for Safir. I disconnected some beam 3D elements degrees of freedom at some nodes to simulate pinned connections (elements do not transfer bending moments in some axes).
When the run is launched; an error message pops up in the screen.
I opened the txt file (in and OUT files are not created) and an error message says the model exceeds the maximum number of beams that can be associated to "Disconnect_Id" (100)
I found that error in the past and tried to overwhelm it generating several Id with the same disconnected degree of freedom so that the number of beams per Id were fewer than 100.
I did not succeed. Does anyone know how to overwhelm this limitation? Otherwise the capacity to disconnect degrees of freedom in Safir - Gid is quite limited.
Thank you in advance !
Javier Unanua
Senior Engineer | Fire Engineering
Arup
C/ Alcalá 54 E28014 Madrid Spain
t +34 91 523 92 76
f +34 91 521 85 75 m +34 696 23 35 31
www.arup.comhttp://www.arup.com/
____________________________________________________________
Electronic mail messages entering and leaving Arup business
systems are scanned for acceptability of content and viruses
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://listas.cimne.upc.edu/pipermail/gidlist/attachments/20120223/5abb8506/attachment.htm