Skipping entities using Rjump mesher
Posted: Wed Apr 22, 2015 5:14 am
Hi,
I am trying to represent a represent a crack surface that is shared by three 3-dimensional volumes. However, I need to skip the lines and sufaces of two of the volumes ( I just need nodes on the shared surface).
I tried Rjump mesher and skip by Lines, but it says "1 line has been rejected because it does not own to 2 (and only 2) HigherEntities." Could you let me know some way to get around this in GID?
Also, as such I don't see an option to skip surface entities, is it possible?
Thanks,
Amit
I am trying to represent a represent a crack surface that is shared by three 3-dimensional volumes. However, I need to skip the lines and sufaces of two of the volumes ( I just need nodes on the shared surface).
I tried Rjump mesher and skip by Lines, but it says "1 line has been rejected because it does not own to 2 (and only 2) HigherEntities." Could you let me know some way to get around this in GID?
Also, as such I don't see an option to skip surface entities, is it possible?
Thanks,
Amit