[GiDlist] (no subject)
Posted: Wed Jan 08, 2003 3:38 pm
I tried to execute Tdyn from a .bat file and there aren't any problem if I use a coarse mesh, but if I use a finer mesh I can't obtain any result and I obtain an .err file :Ransol module is limited to 10.000 nodes. Why?
I tried to execute the .bch file directly from Gid and it runs perfectly.
I need to execute Tdyn from .bat file because it is part of an optimization loop, so how can I do?
Regards
Simone
I tried to execute the .bch file directly from Gid and it runs perfectly.
I need to execute Tdyn from .bat file because it is part of an optimization loop, so how can I do?
Regards
Simone