Structured mesh in a disk (with a hole)

Moderator: GiD Team

Posts: 1
Joined: Fri Apr 12, 2019 11:56 am

Structured mesh in a disk (with a hole)

Postby Laura314 » Fri Apr 12, 2019 12:16 pm

I would like to create a structured mesh similar to the picture attached. Reading some GiD documentation I found this reference:
where the option indicated is:
Mesh -> Structured -> Surfaces -> Center structured

However, I find this way doesn't work well if the geometry presents a hole (as in my geometry).

Is it possible to generate this mesh with GiD? How could I create it?

Thanks!! :P
Wheel_mesh.png (171.72 KiB) Viewed 3839 times
Last edited by Laura314 on Fri Apr 12, 2019 1:20 pm, edited 1 time in total.
User avatar
Posts: 141
Joined: Mon Oct 13, 2014 9:14 am

Re: Structured mesh in a disk (with a hole)

Postby abelcs » Fri Apr 12, 2019 12:51 pm

In your case you need to subdivide your surface (circle with circular hole in the middle) into 4-sided surfaces. Each one of them will be able to be meshed with quadrilateral structured mesh such as the one in the figure.

Return to “Mesh”

Who is online

Users browsing this forum: No registered users and 1 guest