Hello,
In the postprocess, I want to get the result of a specified point (with the coordinate (x,y,z), not just the nodes) at the current step. Is there any Gid_Process or Tcl process that can achieve this requirement?
I think it is similar to the PointEvolution command, but I don't want to generate the graphs, and only the result of the current step is needed.
Looking forward to your advice!
Best Regards
Wentao
how to get the result of a specified point
Moderator: GiD Team
Re: how to get the result of a specified point
Hi,
sorry but at the moment there is no specific Tcl or GiD_Process command to interpolate the result for a point (x,y,z) like PointEvolution does.
we'll add it to the list for the next versions.
the GiDTeam
sorry but at the moment there is no specific Tcl or GiD_Process command to interpolate the result for a point (x,y,z) like PointEvolution does.
we'll add it to the list for the next versions.
the GiDTeam