BEAM_Cross_Section Error
Posted: Wed Jan 27, 2021 4:35 pm
Hi everyone,
I'm currently using GiD 14.1.10d for generating SAFIR 3d structural input file.
It's a simple 3d membrane structure with slab and 2 joist in the middle.
More or less the plan view looks like this:
._______
|______|
|______|
|______|
When I want to create the meshing from this structure, it says "Error when transfering condition 'BEAM_Cross_Section' from geometry to mesh (line 2). It has not been transferred"
I've done several trial and errors and it produced:
1. Remove the shell properties and just use beam properties: the error persists.
2. Remove the beam properties and just use shell properties: it works but not as wanted
3. Set "mesh always by default" to lines: it works but the result is weird - it doesn't show any deflection
From those trial and errors I'm assuming that the problem lies in the beam property?
Did I do something wrong?
What should I do to fix this error?
Thank you!
I'm currently using GiD 14.1.10d for generating SAFIR 3d structural input file.
It's a simple 3d membrane structure with slab and 2 joist in the middle.
More or less the plan view looks like this:
._______
|______|
|______|
|______|
When I want to create the meshing from this structure, it says "Error when transfering condition 'BEAM_Cross_Section' from geometry to mesh (line 2). It has not been transferred"
I've done several trial and errors and it produced:
1. Remove the shell properties and just use beam properties: the error persists.
2. Remove the beam properties and just use shell properties: it works but not as wanted
3. Set "mesh always by default" to lines: it works but the result is weird - it doesn't show any deflection
From those trial and errors I'm assuming that the problem lies in the beam property?
Did I do something wrong?
What should I do to fix this error?
Thank you!