Structured mesh in a disk (with a hole)
Posted: Fri Apr 12, 2019 12:16 pm
Hi!
I would like to create a structured mesh similar to the picture attached. Reading some GiD documentation I found this reference:
https://www.gidhome.com/documents/refer ... Structured
where the option indicated is:
Mesh -> Structured -> Surfaces -> Center structured
However, I find this way doesn't work well if the geometry presents a hole (as in my geometry).
Is it possible to generate this mesh with GiD? How could I create it?
Thanks!!
I would like to create a structured mesh similar to the picture attached. Reading some GiD documentation I found this reference:
https://www.gidhome.com/documents/refer ... Structured
where the option indicated is:
Mesh -> Structured -> Surfaces -> Center structured
However, I find this way doesn't work well if the geometry presents a hole (as in my geometry).
Is it possible to generate this mesh with GiD? How could I create it?
Thanks!!