Creating a tcl file using GiD software
Posted: Sun Feb 24, 2019 3:05 pm
Hi,
I have created a model using GiD software and assigned the nodal conditions and constraints successively (using OpenSees as a problem type)! However, when I press the calculate button to get the tcl file, the error message in the attached picture pops up! Kindly, can you advise on this?
Kind regards
Bashar
I have created a model using GiD software and assigned the nodal conditions and constraints successively (using OpenSees as a problem type)! However, when I press the calculate button to get the tcl file, the error message in the attached picture pops up! Kindly, can you advise on this?
Kind regards
Bashar