Help Required
Posted: Mon Nov 01, 2021 7:10 am
Dear GiD-team,
I want to hollow out the T-shaped bar shape from the block by using GiD.
Then, I tried to hollow out by using [Geometry]-[Edit]-[Volume Boolean op.]-[Substraction].
However, I can not hollow out it.
If possible, would you give me some advice?
Thank you.
I want to hollow out the T-shaped bar shape from the block by using GiD.
Then, I tried to hollow out by using [Geometry]-[Edit]-[Volume Boolean op.]-[Substraction].
However, I can not hollow out it.
If possible, would you give me some advice?
Thank you.