Volume
Posted: Wed Jun 12, 2019 2:35 pm
Hi,
I need to divide a volume into two/three volumes for meshing purpose. I could not divide the volume using GiD/Geometry/Edit/Divide/Volumes/Split. Alternatively, I am trying extrude the volume in steps so that I have more than one volume for the model. My question is whether the created volumes will be in a single part, i.e., do I need to use contact formulation between the common surfaces?
Manish Roy
I need to divide a volume into two/three volumes for meshing purpose. I could not divide the volume using GiD/Geometry/Edit/Divide/Volumes/Split. Alternatively, I am trying extrude the volume in steps so that I have more than one volume for the model. My question is whether the created volumes will be in a single part, i.e., do I need to use contact formulation between the common surfaces?
Manish Roy