Problem dividing a line near a point
Posted: Wed Nov 28, 2018 5:04 pm
I have imported a large curve of 28.5 meters length from a STEP file and I have seen that the representation of the curve is very coarse.
I increased the render precision to 1 but there is no improvement in graphical representation.
The problem come when I try to divide the curve near a point. To select the point I use the Point in Line to have a point in the position where I want to divide the line but the point is not selected or is selected in any other part of the line. I think this behavior is due to the coarse representation because if I divide the line using Num. Divisions the representation is better and I can pick the break point correctly.
Is there any way to increase the precision of the representation of very large curves being possible to pick correctly points in it?
I increased the render precision to 1 but there is no improvement in graphical representation.
The problem come when I try to divide the curve near a point. To select the point I use the Point in Line to have a point in the position where I want to divide the line but the point is not selected or is selected in any other part of the line. I think this behavior is due to the coarse representation because if I divide the line using Num. Divisions the representation is better and I can pick the break point correctly.
Is there any way to increase the precision of the representation of very large curves being possible to pick correctly points in it?