Hello everyone!
I'm trying to sweep the circular surface in order to get a turning, but I always get the massage that I cant sweep circle because the line is closed. Can anybody, please help ? Thank You!
Cylinder SWEEP
Moderator: GiD Team
Re: Cylinder SWEEP
This is a limitation of the copy-sweep tool.
To do this sweep you must avoid the closed curve (the circumference with same start and end point)
You can simply divide this curve in two curves:
Geometry->Edit->Divide->lines->Num divisions
select 2 divisions and the lines to be divided
To do this sweep you must avoid the closed curve (the circumference with same start and end point)
You can simply divide this curve in two curves:
Geometry->Edit->Divide->lines->Num divisions
select 2 divisions and the lines to be divided