[GiDlist] bas file problem

[Mark Smith]

win98 GiD6.3.0b

Dear GiD team,

I am having a problem writing out a mesh data file in my required format.
the following few lines from my .bas file are giving me problems:

*loop elems
*ElemsNum 1 29650 *ElemsMat *ElemsConec
*end elems


no mater what material I asign to my volume before meshing (linear tets),
the output file always shows the value 1 as the elements material.
If I do a write mesh then the output file shows the correct material number?
Whats going on?

Regards
Mark



--------------------------------------------------------------------------
Linx Printing Technologies plc
+44 (0)1480302100
http://www.linx.co.uk/
This e-mail may contain privileged/confidential information and may be
read, copied and used only by the intended recipient. If you have received
it in error, please contact the sender by return e-mail or by
telephoning +44 (0)1480 302100.
Please then delete the e-mail and do not disclose its contents to any
person.

Any information in this message that does not relate to the official
business of Linx shall be understood as neither given nor endorsed by Linx.
We reserve the right to monitor all e-mail communications through our
internal and external networks.
--------------------------------------------------------------------------