[GiDlist] Diagonals ...

[Alisson P. Chaves]

Hello all,

I'm needing to generate meshes with triangular elements using
different diagonal options. Is it possible to make meshes in the
"Union Jack" style, with diagonals in different senses in the GiD ?
Thanks!
Best regards,
alisson
__________________________________________________________
Alisson P. Chaves alisson at dees.ufmg.br
MSc. student
Department of Structural Engineering
Universidade Federal de Minas Gerais
Av. do Contorno 842 - 2o. andar
30110-060 Belo Horizonte, MG, Brasil
__________________________________________________________

[Enrique Escolano]

It is not possible to control the diagonals of the generated triangles.
If your geometry is simple, you can create the surfaces, using copy, etc,
with the final shape
of the desired mesh, and generate after only a element for each surface.

Enrique
----- Original Message -----
From: "Alisson P. Chaves" Alisson at dees.ufmg.br
To: gidlist at gatxan.cimne.upc.es
Sent: Wednesday, January 29, 2003 11:58 AM
Subject: [GiDlist] Diagonals ...


Hello all,

I'm needing to generate meshes with triangular elements using
different diagonal options. Is it possible to make meshes in the
"Union Jack" style, with diagonals in different senses in the GiD ?
Thanks!
Best regards,
alisson
__________________________________________________________
Alisson P. Chaves alisson at dees.ufmg.br
MSc. student
Department of Structural Engineering
Universidade Federal de Minas Gerais
Av. do Contorno 842 - 2o. andar
30110-060 Belo Horizonte, MG, Brasil
__________________________________________________________
_______________________________________________
GiDlist mailing list
GiDlist at gid.cimne.upc.es
http://gid.cimne.upc.es/mailman/listinfo/gidlist