[GiDlist] (no subject)

Moderator: GiD Team

Post Reply
simonelazzara77 at libero.it

[GiDlist] (no subject)

Post by simonelazzara77 at libero.it »

I tried to execute Tdyn from a .bat file and there aren't any problem if I use a coarse mesh, but if I use a finer mesh I can't obtain any result and I obtain an .err file :Ransol module is limited to 10.000 nodes. Why?
I tried to execute the .bch file directly from Gid and it runs perfectly.
I need to execute Tdyn from .bat file because it is part of an optimization loop, so how can I do?
Regards
Simone
Post Reply