Export mesh in different layers
Posted: Tue Mar 20, 2018 12:45 pm
Hello,
I started using GID recently and i found a difficulty that i will try to expose here in the forum.
I'm exporting the geometry from .dxf files, separately by blocks, which i assign in different layers in GID. And then I create the surfaces and volumes. Then I collapse the model, in order to have common lines and nodes, and perform a structured mesh and compatible within the different blocks.
My problem is when I'm exporting the model using a .bas file, where I loop the nodes and elements only for each layer (in order to have different files for each group), it don't write all the nodes in the interfaces (the nodes are not duplicated), and some are in one layer and others in another layer.
Which different strategy could I use in order to have the same results (to have the mesh separately in different export files)?
Thank you.
I started using GID recently and i found a difficulty that i will try to expose here in the forum.
I'm exporting the geometry from .dxf files, separately by blocks, which i assign in different layers in GID. And then I create the surfaces and volumes. Then I collapse the model, in order to have common lines and nodes, and perform a structured mesh and compatible within the different blocks.
My problem is when I'm exporting the model using a .bas file, where I loop the nodes and elements only for each layer (in order to have different files for each group), it don't write all the nodes in the interfaces (the nodes are not duplicated), and some are in one layer and others in another layer.
Which different strategy could I use in order to have the same results (to have the mesh separately in different export files)?
Thank you.