No subject

Moderator: GiD Team

Post Reply
Guest

No subject

Post by Guest »

e.g.
set infoline1 [GiD_Info list_entities lines 1]

Read GiD help about Tcl/Tk extension

Note: I don't know the format that ANSYS require for geometric entities. Maybe is difficult to write it, or ANSYS can't handle
some basic CAD entities like trimmed NURBS surfaces.


Regards

Enrique

----- Original Message -----
From: "Andrea Mordini" Mordini at vce.at
To: gidlist at gatxan.cimne.upc.edu
Sent: Tuesday, July 17, 2007 11:45 AM
Subject: Antw: Re: [GiDlist] points, lines, surfaces and volumes in basfile


Hallo Ramon,

thanks for your quick reply. My problem is very simple:
I would like to write a geometry (and not a mesh) into an ANSYS input file
having the possibility to modify it manually in the file itself without coming back to GiD.
To this purpose, I think the best solution could be what I wrote in the first post:
*loop points
*PointsNum *PointsCoord
*end
and so on.

By generating a mesh that reflects exactly my geometry sometimes, the generated mesh is not exactly
what I want to obtain, especially using 2D and 3D elements.

andrea

--
Andrea Mordini, Structural engineer, Phd
VCE Holding GmbH
Hadikgasse 60, A-1140 Wien
Tel: +43 (1) 897 53 39
Fax: +43 (1) 893 86 71
mordini at vce.at
http://www.vce.at



_______________________________________________
GiDlist mailing list
GiDlist at gid.cimne.upc.es
http://gid.cimne.upc.es/mailman/listinfo/gidlist
Post Reply