GiD forum

Dear Gidlist

I am trying to mesh two volumes; one that is discretised using structured prisma; and one that is discretised using unstructured tetrahedral. These two volumes should be conforming

Two standard error messages within Gid are

1. "Non-structured volumes can only be tetrahedra or only points".

2. "Structured volumes can only be hexahedra"

How exactly can I use Prisma then? All my surfaces are Nurbs.

Apologies if this is a naive question.

Many thanks in advance
Tim Kendon

-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://listas.cimne.upc.edu/pipermail/gidlist/attachments/20051101/52a63a10/attachment.htm

Structured Prisma
Hello, Tim,

Which GiD version are you using?

Abel Coll


----- Original Message -----
From: Kendon, Tim E
To: gidlist at gatxan.cimne.upc.es
Sent: Tuesday, November 01, 2005 3:36 PM
Subject: [GiDlist] Structured Prisma


Dear Gidlist

I am trying to mesh two volumes; one that is discretised using structured prisma; and one that is discretised using unstructured tetrahedral. These two volumes should be conforming

Two standard error messages within Gid are

1. "Non-structured volumes can only be tetrahedra or only points".

2. "Structured volumes can only be hexahedra"

How exactly can I use Prisma then? All my surfaces are Nurbs.

Apologies if this is a naive question.

Many thanks in advance
Tim Kendon


-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://listas.cimne.upc.edu/pipermail/gidlist/attachments/20051102/e61c0e7c/attachment.htm