[GiDlist] Rounding an edge
Posted: Tue Aug 02, 2005 12:10 pm
Win 2000 SP4 GiD 7.5.8b
Is there a geometric procedure like "round" where one specifies a radius
then selects the edges of the solid you wish to modify to blend one surface
into another with the specified radius? or "chamfer/bevel" an edge at a
specified angle?
for lines there is the arc tangent command, but I can not see the 2D/3D
analogy.
regards
mark
The information contained in this e-mail message (and any attachment
transmitted herewith) is privileged and confidential and is intended for the
exclusive use of the addressee(s). If you are not an addressee, any
disclosure, reproduction, distribution or other dissemination or use of this
communication is strictly prohibited. If you have received this
communication in error, please contact us immediately so that we can correct
the error.
Is there a geometric procedure like "round" where one specifies a radius
then selects the edges of the solid you wish to modify to blend one surface
into another with the specified radius? or "chamfer/bevel" an edge at a
specified angle?
for lines there is the arc tangent command, but I can not see the 2D/3D
analogy.
regards
mark
The information contained in this e-mail message (and any attachment
transmitted herewith) is privileged and confidential and is intended for the
exclusive use of the addressee(s). If you are not an addressee, any
disclosure, reproduction, distribution or other dissemination or use of this
communication is strictly prohibited. If you have received this
communication in error, please contact us immediately so that we can correct
the error.