Problem meshing
Posted: Wed Jan 24, 2018 4:21 pm
Hello,
Sometimes, when we try to mesh a domain (especially complex geometries), GiD don't finish the mesh process and the program is closed.
The error message that emerges is 'segmentation fault'. It happens both in 2D and 3D. I wonder if the problem is the geometry or the installation, the version od GiD is 11.0.1. Could you give us any advice or make any recommendation?
Thanks in advance.
Sometimes, when we try to mesh a domain (especially complex geometries), GiD don't finish the mesh process and the program is closed.
The error message that emerges is 'segmentation fault'. It happens both in 2D and 3D. I wonder if the problem is the geometry or the installation, the version od GiD is 11.0.1. Could you give us any advice or make any recommendation?
Thanks in advance.