Contact Us
 

Contact CIMNE

    International Center for Numerical Methods in Engineering
    C1 Building, Campus Norte UPC
    Gran Capitan, s/n
    08034 Barcelona, Spain

Login
 
 
Creating a surface
 Prev:  Rotating and obtaining the final profileMain page
 Next:  Creating a hole in the mechanical part


Creating a surface

  • . Create a NURBS surface. To do this, select the option Geometry->Create->NURBS Surface->By Contour. This option can also be found in the GiD Toolbar.
  • . Select the lines that define the profile of the mechanical part and press ESC to create the surface.
  • . Press ESC again to exit the function. The result is shown in Figure 16.

    • NOTE: To create a surface there must be a set of lines that define a closed contour.

    Creating a surface



     Prev:  Rotating and obtaining the final profileMain page
     Next:  Creating a hole in the mechanical part